SHOW MAC ADDRESS TABLE COMMAND MAC
When a switch receives a unicast frame with a destination MAC address that is listed in the table, it will only send the frame to that port.
If the frame were addressed to 0014.0bd4.0054, the switch would forward the frame to that port only. It will not send the frame to port Fa0/15 only. Until a switch knows where a frame goes, it will send the frame to all ports that are still unknown or unlisted, with the exception of the port on which it arrived. This would be the switch’s behavior if the address of the frame in question was not a broadcast address and was not listed in the MAC address table. It will not send the frame to all ports except the ports listed. These addresses are only used to send to all hosts. I have 4 access switches, 1 core switches, and 1 srx firewall, while i run show arp in srx, yes there lot of output, but when run the same command on core switch or access switch nothing display. Other static/CPU addresses are special mac addresses that are used by the switch. Is there any commands that we can use to show something like show arp that will display mac address, ip address and interface in one table. The address is the Cisco Discovery Protocol (CDP) address. Use this method to obtain the MAC Address of your local computer as well as query remotely by computer name or IP Address. The dynamic addresses have been learned from the network traffic, while the static ones are configured either by default or by the administrator. Note Both the unicast MAC addresses and the multicast MAC addresses allow only one WAN interface. Broadcast addresses are not listed in the MAC address table. The mac-address-table static mac-address vlan vlan-id drop command cannot be applied to a multicast MAC address. It will not prevent the frame from being sent to any ports because the MAC address is not listed. It will also be sent to ports that are as yet unknown by the switch. Displays the mac-address-table for specified ports. If you know the specific mac address, then you can use below command to check mac address entry for that address using show mac address-table address xxxx.xxxx. First of all checking the mac address table by using show mac address-table.
SHOW MAC ADDRESS TABLE COMMAND PC
Even though there has been no network communication initiated across the network (i.e., no use of ping), it is possible that the switch has learned MAC addresses from its connection to the PC and the other switch. Note Both the unicast MAC addresses and the multicast MAC addresses allow only one WAN interface. To manage mac address table, we need to know a couple of commands in Cisco Catalyst switches. In privileged EXEC mode, type the show mac address-table command and press Enter. It will not send the frame only to the ports listed in the table (Fa0/10, Fa0/5, Fa0/8, Fa0/12, Fa0/15, and Fa0/1). The mac-address-table static mac-address vlan vlan-id drop command cannot be applied to a multicast MAC address. It will be sent to all ports listed in the table, or known to the switch, as well as to all those unlisted, or not yet known by the switch. The MAC address is called the Layer 2 broadcast address.
0 kommentar(er)
